Posts Tagged: Schott Mirogard

Anti-reflection Picture Framing Glass – Part 2

This is the second installment to “The Framing Glass” article, which delves into new 99% UV filtering anti-reflective (AR) glass and comparisons of more AR framing glass from Schott, Guardian, Flabeg and Luxar, which were not included in the first article.

Since January 2016, picture framers have been blessed with two exciting new developments. Groglass announced a brand new 99% UV filtering AR glass, with no ripples in the optical coatings, called Artglass UV 99. Tru Vue also launched an updated Museum Glass product, which unlike the earlier product, also has ‘no ripple or “orange peel” effect on [the] glass surface’.

Interference vs Absorptive UV coatings
Both Artglass UV 99 and Museum Glass employ a UV absorptive coating on one side of the sheet, and then AR coatings are applied to both sides. Since the UV filtering coating is an absorptive type, it is effective at all angles of light entry. I consider these to be the only meaningful products to use if UV filtering is required.

Other products such as Artglass WW UV (>90% UV protection), Flabeg ArtControl UV90 (>90% UV protection) and Schott Mirogard Plus (~84% UV protection) use interference-based coatings to block UV light. There are three downsides to that. Firstly, they can only achieve a maximum 90% or so UV filtration between 300-380nm. This doesn’t sound too bad until the transmission band shift at oblique incident light angles is considered. So the second problem is the transmission band shifts to shorter wavelengths when light strikes the glass at shallower angles, allowing more UV light to pass through. Since in practice no artwork is illuminated solely straight on (the viewer’s shadow will be in the way), the added UV protection in the real world is not as significant as their manufacturer specifications would suggest. Thirdly, interference-based coatings tend to have a wide cut-off band, as seen in the spectral transmission graphs of Museum Glass and Artglass WW UV in the earlier article.

New Museum Glass vs Artglass UV 99 coating ripples casting shadows comparison

Artglass UV 99 and new Museum Glass
Both products have largely similar specifications: AR coatings resulting in less than 1% reflection, 99% UV filtration (from 280nm-380nm for Artglass UV 99 and from 300-380nm for Museum Glass) and similar glass thicknesses, the standard products are 2mm for Artglass and 2.5mm for Museum Glass. The base substrate is regular soda lime float glass rather than low iron glass. The UV absorbing coating is an orangey-brownish color so when combined with the aqua green color of regular glass, they balance each other out resulting in a visually more neutral transmission color. Using low iron glass does increase the overall transmission a little but since it is so neutral, adding the UV coating makes it look overly yellowish in tint. The transmission rating for both is ~97%, though AR glass with lower UV protection ratings tend to have better transmission ratings, up to >99%.

Both manufacturers also claim to have no rippling pattern in their coatings. The previous version of Museum Glass was plagued by quite serious ripples in the UV coatings, which became even more obvious under non-diffused light sources. Let us first investigate these claims.

Continue Reading…